Single sided MDF paw print earring blanks are approximately 1/8" thick, glossy white on the front and brown on the back, perfect for sublimation. Perfect for school spirit panther paws, cat print, or dog prints!

✔️Single Sided MDF - approximately 1/8"thick
✔️Available in multiples of 5 sets
✔️Choose from multiple sizes
✔️Canva Templates may be available, reach out if you cannot find in our shop!

🚫 Does not include hardware

📏APPROXIMATE SIZES:

Post: 0.50” h x 0.55” w (fits 3mm posts or smaller - not included)
Post: 0.75” h x 0.85” w (fits 3mm posts or smaller - not included)
Dangle: 1.00” h x 1.13” w
Dangle: 1.50” h x 1.70” w
Dangle: 2.00” h x 2.25” w

❓ Worried about getting the settings right? Add a Scrap Pack to test your settings before using your good blanks!

Sublimation Instructions:
* Remove plastic film
* If necessary, clean any remaining smoke residue with soft cloth and rubbing alcohol.
* Press at 380-400 degrees, medium pressure for 50-60 seconds.

Use the following as a suggestion, your settings may vary depending on your equipment.

⭐ Remove plastic film

⭐ Clean any remaining smoke residue with soft cloth and rubbing alcohol.

⭐ Press at 380-400 degrees, medium pressure for 50-60 seconds.