❗️ FYI: Please note that we will be transitioning to the new UNISUB single sided material as the previous material is depleted. You can read about the changes here: https://tinyurl.com/MDFChanges If this is an issue please reach out BEFORE you order. *This only affects the single sided blanks* ❗️

Single (SGL) or double (DBL) sided MDF hardboard blank is approximately 1/8" thick, glossy white layer(s) are perfect for sublimation.

✔️Choose Single (SGL) or Double (DBL) Sided MDF - approximately 1/8"thick
✔️Available in multiples of 5
✔️Choose from multiple sizes

🚫 Templates for this design are NOT available
🚫 Does not include hardware

📏APPROXIMATE SIZES:

0.50”h x 0.62”w - Post
0.75”h x .92”w - Dangle or Post
1.00”h x 1.23”w - Dangle
1.50”h x 1.85”w - Dangle or Post
1.75”h x 2.15”w - Dangle or Post

❓ Worried about getting the settings right? Add a Scrap Pack to test your settings before using your good blanks!

Sublimation Instructions:
* Remove plastic film
* If necessary, clean any remaining smoke residue with soft cloth and rubbing alcohol.
* Press at 380-400 degrees, medium pressure for 50-60 seconds.

Use the following as a suggestion, your settings may vary depending on your equipment.

⭐ Remove plastic film

⭐ Clean any remaining smoke residue with soft cloth and rubbing alcohol.

⭐ Press at 380-400 degrees, medium pressure for 50-60 seconds.