❗️ FYI: Please note that we will be transitioning to the new UNISUB single sided material as the previous material is depleted. You can read about the changes here: https://tinyurl.com/MDFChanges If this is an issue please reach out BEFORE you order. *This only affects the single sided blanks* ❗️

Custom cut round, double sided MDF with 1/16" hole(s) approximately, cut less than 1/8" from edge.

🚫 Custom cuts are NON REFUNDABLE, but please reach out if you have issues.

📏APPROXIMATE SIZES: 3" x 3", 2.5" x 2.5"

✔️Double Sided MDF - approximately 1/8" thick
✔️Available in multiples of 5
✔️Canva Templates may be available, reach out if you cannot find in our shop!

🚫 Does not include hardware, jewelry, etc.; listing is for the BLANK ONLY

❓ Worried about getting the settings right? Add a Scrap Pack to test your settings before using your good blanks!

Sublimation Instructions:

• Remove plastic film.
• If necessary, clean remaining smoke residue with soft cloth and rubbing alcohol.
  
• Press at 380-400 degrees, medium pressure for 50-60 seconds.
• Save your good blanks - Get our Scrap Pack to test your settings

Use the following as a suggestion, your settings may vary depending on your equipment.

⭐ Remove plastic film

⭐ Clean any remaining smoke residue with soft cloth and rubbing alcohol.

⭐ Press at 380-400 degrees, medium pressure for 50-60 seconds.