Santa hat shaped single sided MDF hardboard blanks are approximately 1/8" thick, glossy white on the front and brown on the back, perfect for sublimation.
āļøSingle Sided MDF - approximately 1/8"thick
āļøAvailable in multiples of 5 sets
āļøChoose from multiple sizes
āļøCanva Templates may be available, reach out if you cannot finĀ
š« Does not include hardware
šAPPROXIMATE SIZES:
Dangle: 2.0āh x 2.50āw
Dangle: 1.5āh x 1.75āw
Dangle: 1.0āh x 1.25āw
Post: 0.50āh x 0.75āw
ā Worried about getting the settings right? Add a Scrap Pack to test your settings before using your good blanks!
Sublimation Instructions:
* Remove plastic film
* If necessary, clean any remaining smoke residue with soft cloth and rubbing alcohol.
* Press at 380-400 degrees, medium pressure for 50-60 seconds.
Use the following as a suggestion, your settings may vary depending on your equipment.
ā Remove plastic film
ā Clean any remaining smoke residue with soft cloth and rubbing alcohol.
ā Press at 380-400 degrees, medium pressure for 50-60 seconds.
Candyland StudioĀ is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to candylandstudio.com.
