❗️ FYI: Please note that we will be transitioning to the new UNISUB single sided material as the previous material is depleted. You can read about the changes here: https://tinyurl.com/MDFChanges If this is an issue please reach out BEFORE you order. *This only affects the single sided blanks* ❗️

Single sided MDF hardboard blank is approximately 1/8" thick, glossy white on the front (perfect for sublimation) and brown on the back.

✔️Single Sided MDF - approximately 1/8" thick
✔️Available in multiples of 5 sets
✔️Choose from multiple sizes
✔️Canva Templates available HERE in our shop!

🚫 Does not include hardware

📏APPROXIMATE SIZES:

Post: 0.75"h x 0.60"w
Dangle: 1.0"h x 0.80"w
Dangle: 1.5"h x 1.20"w
Dangle: 2.0"h x 1.60"w

❓ Worried about getting the settings right? Add a Scrap Pack to test your settings before using your good blanks!

Sublimation Instructions:
* Remove plastic film
* If necessary, clean any remaining smoke residue with soft cloth and rubbing alcohol.
* Press at 380-400 degrees, medium pressure for 50-60 seconds.

Use the following as a suggestion, your settings may vary depending on your equipment.

⭐ Remove plastic film

⭐ Clean any remaining smoke residue with soft cloth and rubbing alcohol.

⭐ Press at 380-400 degrees, medium pressure for 50-60 seconds.