Sublimate your designs on these square shaped earring blanks cut from single sided UNISUB material.

📏 APPROXIMATE SIZES:

1.0" x 1.0"
1.5" x 1.5"
2.0" x 2.0"

✔️Single Sided MDF - approximately 1/8" thick
✔️Available in multiples of 5 sets
✔️Canva Templates may be available, reach out if you cannot find in our shop!

🚫 Does not include hardware, jewelry, connectors, etc.; listing is for the BLANK ONLY

❓ Worried about getting the settings right? Add a Scrap Pack to test your settings before using your good blanks!

Sublimation Instructions:
* Remove plastic film
* If necessary, clean any remaining smoke residue with soft cloth and rubbing alcohol.
* Press at 380-400 degrees, medium pressure for 50-60 seconds.

Use the following as a suggestion, your settings may vary depending on your equipment.

⭐ Remove plastic film

⭐ Clean any remaining smoke residue with soft cloth and rubbing alcohol.

⭐ Press at 380-400 degrees, medium pressure for 50-60 seconds.