Sublimate your Halloween designs on these triple fright dangle earrings cut from single or double sided UNISUB material.

📏APPROXIMATE SIZES:

Bat: 0.60"h x 1.19"w
Pumpkin: 0.62"h x 0.62"w
Ghost: 0.75"h x 0.60"w

✔️Single or Double Sided MDF - approximately 1/8"thick
✔️Available in multiples of 5 sets
✔️PNG Template available upon request

🚫 Does not include hardware, jewelry, beads, connectors, etc.; listing is for the BLANK ONLY

❓ Worried about getting the settings right? Add a Scrap Pack to test your settings before using your good blanks!

Sublimation Instructions:
* Remove plastic film
* If necessary, clean any remaining smoke residue with soft cloth and rubbing alcohol.
* Press at 380-400 degrees, medium pressure for 50-60 seconds.

Use the following as a suggestion, your settings may vary depending on your equipment.

⭐ Remove plastic film

⭐ Clean any remaining smoke residue with soft cloth and rubbing alcohol.

⭐ Press at 380-400 degrees, medium pressure for 50-60 seconds.