Sublimate your designs on these square shaped earring blanks cut from single sided UNISUB material.
📏 APPROXIMATE SIZES:
1.0" x 1.0"
1.5" x 1.5"
2.0" x 2.0"
✔️Single Sided MDF - approximately 1/8" thick
✔️Available in multiples of 5 sets
✔️PNG Template available upon request
🚫 Does not include hardware, jewelry, connectors, etc.; listing is for the BLANK ONLY
❓ Worried about getting the settings right? Add a $1 Scrap Pack to test your settings before using your good blanks!
* Remove plastic film
* If necessary, clean any remaining smoke residue with soft cloth and rubbing alcohol.
* Press at 380-400 degrees, medium pressure for 50-60 seconds.
Use the following as a suggestion, your settings may vary depending on your equipment.
⭐ Remove plastic film
⭐ Clean any remaining smoke residue with soft cloth and rubbing alcohol.
⭐ Press at 380-400 degrees, medium pressure for 50-60 seconds.
Amazon Affiliate Disclosure
Candyland Studio is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to candylandstudio.com.